The Top FAQ’s
For over 50 years ,Aercon has been leading the way for air pressure control solutions worldwide. We understand the importance of clean air in critical situations and we are pioneering in our ongoing efforts to develop the world’s leading air pressure control valves.
To help you understand if Aercon products are for you and to assist the selection of the right product every time we have developed an FAQ page with the most frequently asked questions from customers.
The pressure stabilisers typically start to open at 10% below the required pressure setting and fully open at the required pressure setting. i.e. If a pressure stabiliser is set at 10 Pa, the blade(s) should start to open at around 9 Pa .
The range of wall depth will differ between the different ranges of products we manufacture. Across all our products, custom sizes are available – contact our office for further advice.
We do not advise customers to adjust the balance weights on site and request that you contact our office for further advice.
Aercon’s pressure stabilisers do not function appropriately if fitted in a ceiling or orientated in a similar manner.
No, we can offer various sizing depending on your requirements, contact our office for further advice.
Yes, we can offer site surveys dependent on further discussion and requirements. Please contact the office to discuss further.
Lead times vary dependant on current workloads, however approximately 5-7 w/weeks
Yes, we can work out stabiliser sizes needed, if you supply us with any drawings, airflow rates and pressures then we can go from there.
Yes, a maintenance service is available dependent on requirements, please contact the office for further advice on the best product required.
If we haven't answered your question or you wish to talk about your air pressure control needs, please do not hesitate to contact us today.